A loose power jack can damage the trace inside the hole in the system board. Then, I connected an external LCD monitor and it worked, all the display was ok on the external monitor. I used a shop vac to get the dirt out then I followed the instructions and applied Artic Silver to the cpu. On the verge of throwing the Toshiba into the gargage I found this site and dismatled the darn thing. What can be the reason of such problems? If you have 2 memory modules installed try removing them one by one and run the restore with only one module installed. I would have to apply pressure at the bottom between the battery and memory card cover in order to have the green light to come, but that dont work any more.
|Date Added:||28 January 2013|
|File Size:||63.66 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Do you hear any sounds? The Setup screen will appear. But they told me that this memory can not be replace. Use any piece of plastic if you do not have a guitar pick.
BIOS Setup / BIOS settings — access instructions
Take a look at the last picture in this post and check your jack again. I changed a Celeron 2.
The blue light stays on, but if i move the laptop the blue light goes off. If you get video, start adding parts one by one. As time goes on, it would turn on for 3 seconds and then turn back off. Any thoughts on things i should check? Finally if this all comes to the crunch point is it cost effective to change the board and if so where would be a good place to source it?
Thanks toshiba satellite m35x – s349 any help! Most likely your system board was replaced before because of this problem. Would it be possible for toshiba satellite m35x – s349 to work enough to power my laptop but not enough to charge the battery, even when the computer is off?
I have the Toshiba CDs, but the only option I am given will reformat the drive, so all my info will be lost. It was total black.
I also tried to search eBay without any luck. I decided to retry applying the ceramique paste. I advice you check the support website of toshiba, which toshiba satellite m35x – s349 support. Now it wont turn on at all. Check if the same garbled video lines and pixels appears on an external monitor. Hey Frank, That is a tough one. Thanks for the great website.
Batterie ordinateur portable
Brandon, To remove the motherboard I need minutes. Carlosâ€” I did just thought.
It also could be a problem with the power cord. There is no Pentium M in the list, but if I understand correct the main difference between CPUs is the clock speed.
Blowing out the heatsink I can do myself. Hi Tim, you are not bugging me at all. One particular thing is that the time never change, not even in the BIOS.
Satelpite bad I did the soldering before finding this page. There should be a place where you can change timing for the system standby.
It should also help to make your laptop quieter. See if the power cuts off when toshiba satellite m35x – s349 jiggle the power cord.
You can install any LCD you can find and afford.
Toshiba Satellite M35X A75 power jack problem | Laptop Repair
I would think that if either of those components were bad enough to cause failures as often as I see them, that they would show up rather quickly in each of those tests. Otherwise, Im gonna keep a look out and hope a cheaper board comes along!
Toshiba satellite m35x – s349 am puzzled though. Jesse, Yep, you still have to take the whole thing apart and remove the motherboard if you plan replacing the power jack. satllite
Well I got the adapter and it is the right output 19V 6.